Standard Brass Button for 9/16-20 Lance

.156 thru hole

Available in lots of 25 pieces

Replacement for all standard brass buttons

Retaining Screw for BB-25 Nozzle

3/8-24 Thread -- 5mm Allen Head Tip

Works up to 55,000 PSI

Retaining Screw for:

BB-25 Nozzle          2806 Series

Retaining Screw for Low-Mass Nozzle

3/8-24 Thread -- 5mm Allen Head Tip

Works up to 55,000 PSI

Retaining Screw for:

 Low-Mass Nozzle          2806 Series

Type D Jewel Sleeve Replacement

Works up to 55,000 PSI

Repair old nozzles in the field with these replacement sleeves.

Replacement for all original Type D sleeves

Screwdriver for Type D Nozzle

Hex Tip

Used for repairing, rebuilding and installing Type D Nozzles while in the field

Screwdriver for:

Type D Nozzle            2805 Series

WaterJetting Sapphires

0-60,000 PSI

Available in .004-.044 (Special Sizes available upon request)

100% Authentic Swiss Made Sapphires

Replacement for standard sapphire

Standard Jewel Sleeve Replacement

Works up to 44,000 PSI

Repair old nozzles in the field with these replacement sleeves.

Replacement for original sleeve in:

Low-Mass Nozzle          2806 Series

BB-25 Nozzle                2807 Series

3/8-24 LT Nozzle         2808 Series

Metric LT Nozzle           2809 Series

7/16-20 LT Nozzle      2810 Series

Length: 2.6 Inches

Used For: Extending the length of nozzles

Nozzle: Designed to extended 3/8-24 Nozzles (2808) Series

Nozzle Extenders or Nozzle Attenuators as they are also known, are a great addition to any blasting set-up. Extenders do not only allow to to move closer to a blast surface. They also serve a much more important purpose.

As water travels from the pump through hoses, swivels, etc., the UHP water picks up a lot of turbulence, which can lead to poor stream quality and poor nozzle performance. Bingham Mfg. Nozzle Extenders are designed to remove turbulence from your water before it hits the end of the nozzle, resulting in a sharper, better stream of water and increased performance.