Make no mistake, we believe that every waterblast company in the world can benefit from owning a Wolf Gun. However, we also recognize that in some cases, it's simply not possible. Large companys can own dozens and dozens of existing guns that are years old, continue to fail and drive down productivity. We've seen it a hundred times and after years of discussion, we have finally released a gun conversion kit for nearly every common UHP gun in the world.

Now, using Wolf Gun Technology from Bingham Mfg. is simple and affordable, even if you have an entire fleet of old guns.

Conversion Kits

Vulcan Stripper™ Style	BMI # 110000A
A-3000® Style	BMI # 120000A
Tornado™ Style	BMI # 130000A
NLB® Style	BMI # 140000A
Jet-Tech® Style	BMI # 150000A
Jet-Edge® Style	BMI # 160000A

Converting to Wolf Gun Technology is a simple 3-step process

Step 1:

Disassemble your original waterblast gun, until the original air motor and 2nd trigger (If you choose to use one, not required).

Step 2:

After you have removed original air motor, install the swivel / lance pack into the top of the new mounting plate. Then, install the top and bottom mounting plates togeather over the air motor and secure in place. Most of the hard work is now finished.

Step 3:

Install the lance shroud over the new lance and secure the shroud plate to the mounting plates. Now install your original 2nd trigger (If you choose to use one). Install the bearing alignment pack on the end of the shroud. Install your nozzle carrier and nozzles, and youre ready to blast.

Most Wolf Gun conversions can be accomplished in less than 30 minutes by a knowledgable technician.